Recently, during the consultation about the use of Xiaoju’s smart disinfection toothbrush holder, I received There are many inquiries about squeezing toothpaste parts. Xiaoju hereby sorts out one by one to answer questions for users and friends:
1. Which toothpaste is suitable?
Conventional, spiral or straight toothpaste can be adapted. The mouth of the toothpaste is volcanic, or it is particularly unsuitable.
2. How to install toothpaste?
When installing, aim at the position of the toothpaste, apply a little force, and rotate the plug to install it.
3. Why is there no toothpaste? (Why is it difficult to squeeze out toothpaste and the amount of toothpaste is small)
1. Please check to make sure that the toothpaste extrusion port is facing outward. If it is on the inside, take it off and rotate it 180°.
2. For the first use, it needs to be pushed for many times, so that the toothpaste can fill the squeezing toothpaste until it is pushed and squeezed Just put out the toothpaste.
3. Push the frequency slower and push it deeper. (When pushing to the bottom, you can stay for a second or two)
4. Special types of toothpaste may be produced in small amounts due to the limitations of raw materials, such as a single extrusion amount is not enough , Can be squeezed once more.
4. How to install the toothpaste squeezer after disassembly and cleaning?
Please follow the steps below to install:
5. Is the location of squeezing toothpaste sealed? How to get toothpaste?
1. The space for squeezing toothpaste is naturally closed, and the paste will only come out when pushed.
2. The toothbrush holder uses the principle of negative pressure to suck out the toothpaste, so when installing the toothpaste, you need to use some force to stuff the toothpaste into it, to ensure that there is no gap in the middle. Push the push plate a few more times, and the toothpaste will come out.
6. Is there any disinfection at the location of squeezing toothpaste?
Some of the area where the toothpaste is squeezed is exposed to ultraviolet light, but it is not 100% disinfected because the right side of the toothpaste is not exposed to ultraviolet light.
7. What should I do if the toothpaste solidifies?
1. Toothpaste parts can be disassembled and cleaned. Twist counterclockwise, then take out the whole. All components can be disassembled, and can be replaced as they are during installation.
2. The setting time of different toothpastes is different. It will be more difficult to push the paste out of special toothpaste types. It needs to be pushed several times or pushed to the end At the time of the Ministry, stay a little for a second or two.
